Lasercut extracts laser cutter information from the “syscfg.ini” file stored next to its executable. Selecting the appropriate Laser cutterįor the first execution of the lasercut program simply run the appropriate labelled “.bat” file from the install directory. There are workarounds which allow you to prepare files while using the demonstration version. This version of the software has limited capabilities in particular it does not allow you to save your work and it does not connect to the laser cutter (the program will crash if this is attempted). The demo version of Lasercut, “Lasercut53_Demo.exe”, will run even if the softdog USB dongle is not present. You can download jobs to the laser, adjust the cutting position and start a job all from within Lasercut. This version gives you complete control over the laser cutter. The full version of Lasercut, “Lasercut53.exe”, will only run if the softdog USB dongle is connected to the computer. There are two versions of Lasercut located within the program path, a full version and a demonstration version. Windows will then determine which driver is best for your version of windows and update appropriately. Select Update driver and then manually select the folder downloaded in the first step. To manually update the driver right click to item in device manager. If the USB dongle has not installed correctly it will appear as EZ-USB-FX2 with a warning symbol next to it. If the drivers have installed correctly then they will appear in the device manager as shown above. Checking the DriversĬonnect both the Laser cutter and the USB dongle to the computer. Once complete navigate to the newly created folder to start the program. The program will install Lasercut, the drivers for the USB dongle and the drivers for the laser cutter. Like most older programs Lasercut prefers to run from the default paths. The ‘Lasercut53′ type is a standalone version of Lasercut which can be used in demonstration mode without the need for the softdog dongle. Install Lasercut using the default settings. Run the “Setup.exe” program from within the LaserCut 5.3 folder, this will start the installation of Lasercut 5.3 In a typical install all the required drivers will be set up as part of the Lasercut Installer, the additional drivers are only provided for completeness. The driver to connect directly to the laser cutter. An additional driver for the USB dongle if you are using a 64 bit version of Windows 7 This is used to prepare the cutting files before sending them to the laser Extract the files from the zipped archive to a new directory. The Lasercut 5.3 installation files can be downloaded here. Having problems with your laser cutter or software? Try our new community forum:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |